Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Page 118 FT DX 3000 O peraTing M anual061 CW BK-INFunction: Sets the CW “break-in” mode.Available Values: SEMI/FULLDefault Setting: SEMISEMI: The transceiver will operate in the semi break-inmode. The delay (receiver recovery) time is setvia the Menu item “062 CW BK-IN DELAY”.FULL: The transceiver will operate in the full break-in(QSK) mode.062 CW BK-IN DELAYFunction: Adjusts the Keying Delay (receiver recovery)time on the CW mode.Available Values: 30 ~ 3000 msec (10 msec/step)Default Setting: 200 msec063 CW WAVE SHAPEFunction: Selects the CW carrier wave-form shape (rise/fall times).Available Values: 1/2/4/6 msecDefault Setting: 4 msec064 CW FREQ DISPLAYFunction: Selects the frequency Display Format for theCW mode.Available Values: DIRECT FREQ/PITCH OFFSETDefault Setting: PITCH OFFSETDIRECT FREQ: D i s p l a y s t h e r e c e i v e r c a r r i e rfrequency, without any offset added.When changing modes betweenSSB and CW, the frequency displayremains constant.PITCH OFFSET: This frequency display reflects theadded BFO offset.065 PC KEYINGFunction: Enables/disables CW keying from the USBjack on the rear panel, while operating on the CW mode.Available Values: OFF/DTR/RTSDefault Setting: OFF066 QSKFunction: Selects the time delay between when thePTT is keyed and the carrier is transmitted during QSKoperation when using the internal keyer.Available Values: 15/20/25/30 msecDefault Setting: 15 msecMODE-DATA Group067 DATA MODEFunction: Selects the operation mode of the DATAmode.Available Values: PSK/OTHERDefault Setting: PSK068 PSK TONEFunction: Selects the PSK tone frequency.Available Values: 1000/1500/2000 HzDefault Setting: 1000 Hz069 OTHER DISP (SSB)Function: Sets the packet frequency display offset.Available Values: -3000 ~ 0 ~ +3000 Hz (10 Hz/step)Default: 0 Hz070 OTHER SHIFT (SSB)Function: Sets the carrier point during the SSB packetoperation.Available Values: -3000 ~ 0 ~ +3000 Hz (10 Hz/step)Default: 1000 Hz (typical center frequency for PSK31,etc.)071 DATA LCUT FREQFunction: Selects the cutoff frequency of the lower sideof the RX audio filter in the DATA mode.Available Values: OFF/100 ~ 1000 Hz (50 Hz/step)Default Setting: 300072 DATA LCUT SLOPEFunction: Selects the filter slope of the lower side of theRX audio filter in the DATA mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 18dB/oct073 DATA HCUT FREQFunction: Selects the cutoff frequency of the upper sideof the RX audio filter in the DATA mode.Available Values: OFF/700 ~ 4000 Hz (50 Hz/step)Default Setting: 300074 DATA HCUT SLOPEFunction: Selects the filter slope of the upper side of theRX audio filter in the DATA mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 18dB/octM enu MODe