Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Page 117FT DX 3000 O peraTing M anualMODE-AM Group048 AM LCUT FREQFunction: Selects the cutoff frequency of the lower sideof the RX audio filter in the AM mode.Available Values: OFF/100 ~ 1000 Hz (50 Hz/step)Default Setting: OFF049 AM LCUT SLOPEFunction: Selects the filter slope of the lower side of theRX audio filter in the AM mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 6dB/oct050 AM HCUT FREQFunction: Selects the cutoff frequency of the upper sideof the RX audio filter in the AM mode.Available Values: OFF/700 ~ 4000 Hz (50 Hz/step)Default Setting: OFF051 AM HCUT SLOPEFunction: Selects the filter slope of the upper side of theRX audio filter in the AM mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 6dB/oct052 AM MIC GAINFunction: Sets the microphone gain for the AM mode.Available Values: MVCR/0 ~ 100Default Setting: 30When this menu is set to “MCVR”, you may adjust themicrophone gain using the front panel [MIC/SPEED]knob.053 AM MIC SELFunction: Selects the microphone to be used in the AMmode.Available Values: FRONT / DATA / USBDefault Setting: FRONTFRONT: Selects the microphone connected to thefront panel MIC jack while using the AMmode.DATA: Selects the microphone connected to pin 1 ofthe PACKET Jack while using the AM mode.USB: Selects the microphone connected to USBJack while using the AM mode.MODE-CW Group054 CW PITCHFunction: Adjusts your preferred CW tone pitch.Available Values: 300 ~ 1050 Hz (50 Hz/step)Default Setting: 700 Hz055 CW LCUT FREQFunction: Selects the cutoff frequency of the lower sideof the RX audio filter in the CW mode.Available Values: OFF/100 ~ 1000 Hz (50 Hz/step)Default Setting: 250056 CW LCUT SLOPEFunction: Selects the filter slope of the lower side of theRX audio filter in the CW mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 18dB/oct057 CW HCUT FREQFunction: Selects the cutoff frequency of the upper sideof the RX audio filter in the CW mode.Available Values: OFF/700 ~ 4000 Hz (50 Hz/step)Default Setting: 1200058 CW HCUT SLOPEFunction: Selects the filter slope of the upper side of theRX audio filter in the CW mode.Available Values: 6dB/oct / 18dB/octDefault Setting: 18dB/oct059 CW AUTO MODEFunction: Enables/disables CW keying while operatingon SSB.Available Values: OFF/50M/ONDefault Setting: OFFOFF: Disables CW keying while operating on SSB.50: Enables CW keying only while operating SSB on50 MHz (but not HF).On: Enables CW keying while operating on SSB (allTX bands).060 CW BFOFunction: Sets the CW carrier oscillator injection sidefor the CW mode.Available Values: USB/LSB/AUTODefault Setting: USBUSB: Injects the CW carrier oscillator on the USBside.LSB: Injects the CW carrier oscillator on the LSBside.AUTO: Injects the CW carrier oscillator on the LSBside while operating on the 7 MHz band andbelow, and the USB side while operating on the10 MHz band and up.M enu MODe