113Communicating with a Specific Remote StationUsing the Tone Squelch Function4 Touch [SRCH].[DCS SEARCH] appears on the LCD.The transceiver starts to search for the DCS code.When a corresponding DCS code is detected, a beep isemitted and searching stops temporarily. The detectedDCS code blinks.Tip To stop searching, touch [STOP].Tip To set the searched DCS code,Touch [STOP]. → Hear the beep sound. → Gently press the key 3 times.The transceiver exits from Set mode.TipFor setting how the transceiver operates when scanning stops, see “Setting the Receive OperationWhen Scanning Stops” on page 74.Notification of a Call from a Remote Station by VibrationSet the vibrator to alert you of a call from a remote station containing a correspondingtone or DCS code.1 Press and hold the key for over one second.The transceiver enters Set mode.2 Touch [CONFIG].3 Touch [22 VIBRATOR].4 Rotate the DIAL to select [MODE], then press the key.5 Rotate the DIAL to select [SIGNALING].6 Press .The vibrator setting is set and the transceiver exits from the Set mode.Tip To deactivate the vibrator function, select [OFF] in step 5.