114Communicating with a Specific Remote StationUsing the Tone Squelch FunctionTips• The vibrator can function for all frequency bands belonging to A-band (Main) and B-band (Sub).• If you select [BUSY] in step 5, when the transceiver receives a signal, BUSY LED and the vibrationfunction turn on simultaneously regardless of the communication mode or squelch type.• The vibrator functions when the vibrator setting is other than OFF. Press to perform transmission,and release to deactivate the vibrator for 5 seconds.Selecting the Vibrator Operation Mode1 Press and hold the key for over one second.The transceiver enters Set mode.2 Touch [CONFIG].3 Touch [22 VIBRATOR], then press the key.4 Rotate the DIAL to select [SELECT], then press the key.5 Rotate the DIAL to select the desired vibrator operation.Remark The default setting: PATTERN1PATTERN1 The vibrator functions continuously.PATTERN2 The vibrator functions at long intervals.PATTERN3 The vibrator functions at short intervals.6 Press .The selected vibrator operation is set and the transceiver exits from Set mode.Notification of a Call from a Remote Station by theBell FunctionSet the Bell sound to alert you of a call from a remote station containing a correspondingtone or DCS code. on the LCD blinks at the same time.1 Press and hold the key for over one second.The transceiver enters Set mode.2 Touch [SIGNALING].3 Touch [1 BELL].
