79Scanning FunctionMemory Channel ScanningScanning the Memory BankOnly the memory channels in the recalled memory bank can be scanned.1 Press the key to enter Memory mode.2 Touch [F MW].3 Touch [BANK].4 Press the key.5 Rotate the DIAL to select the desired memory bank fromBANK 1 to BANK 24.6 Press the key.7 Touch [F MW].8 Touch [SCAN].Tips • Scanning is performed toward the higher memory channel numbers.• Rotate the DIAL clockwise: Scanning is performed toward the higher memory channel numbers.Rotate the DIAL counterclockwise: Scanning is performed toward the lower memory channelnumbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequency isreceived.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To stop scanning, press .• You can select the range for scanning by pressing and holding the key for over onesecond to enter Set mode, then selecting [SCAN] → [5 SCAN WIDTH].Memory Bank Link ScanningDuring regular memory bank scanning, only thememory channels assigned to the recalled memorybank are scanned. During memory bank link scanning,you can scan memory channels registered in two ormore banks you specified in advance.1 Press and hold the key for over one second.The transceiver enters Set mode.2 Touch [MEMORY].3 Touch [1 BANK LINK].4 Rotate the DIAL to select the memory bank for which you want to perform bank linkscanning.5 Press the key.☒ is displayed for the selected memory bank and □ is displayed for unselectedmemory bank.6 Repeat steps 4 and 5 to select other memory banks.7 Press .The transceiver exits from Set mode.BANK 1 BANK 10BANK 24