146Customize Menu Settings for Individual Use (Set Mode)Set Mode: CONFIG Menu OperationsSetting the Key Operation Confirmation SoundSet whether or not a beep sound is emitted to confirm when keys are operated, whenscanning reaches the end of a frequency band, or when a band edge/CH1 is encountered.1 Touch [3 BEEP].2 Rotate the DIAL to select [SELECT], then press the key.3 Rotate the DIAL to select the desired setting referring to the table below.KEY &SCANEmits the beep sound when a key is operated or scanning stops.KEY Emits the beep sound when a key is pressed.OFF Mutes the beep sound.Remark The default setting: KEY & SCAN4 Press the .5 Rotate the DIAL to select [EDGE], then press the key.6 Rotate the DIAL to select the desired setting referring to the table below.OFF No confirmation sound is emitted when a band edge/CH1 is encountered.ON Emits the confirmation sound when a band edge/CH1 is encountered.Remark The default setting: OFFTurning off the BUSY IndicatorWhen listening to the radio continuously or to extend the remaining battery operatingtime, turn off the BUSY indicator to save battery power consumption.1 Touch [4 BUSY LED].2 Rotate the DIAL to select “A BAND”, “B BAND” or “RADIO”, then press the key.3 Rotate the DIAL to select the desired setting.ON Turns on the BUSY indicator.OFF Turns off the BUSY indicator.Remark The default setting: ON4 Press the key.5 To change the setting for other bands, repeat steps 2 to 4.