133Customize Menu Settings for Individual Use (Set Mode)Set Mode: TX/RX Menu OperationsSwitching the Receive ModeManually switch to a suitable mode (radio wave type) according to the frequency band byselecting [1 MODE] → [3 RX MODE].For details, see “Changing the Mode” on page 48.Setting the Squelch Type for the Digital ModeSet the squelch type for the digital mode.1 Touch [2 DIGITAL].2 Touch [1 SQL TYPE].3 Rotate the DIAL to select [SQL TYPE], then press the key.4 Rotate the DIAL to select the desired squelch type.OFF Audio is always output upon receiving a digital signal from a Yaesutransceiver.CODE Audio is output only when receiving a signal with a correspondingSQL CODE.BREAK Audio is output regardless of any squelch code when the remotestation transmits with BREAK set.Remark The default setting: OFF5 Press the key.6 Rotate the DIAL to select [SQL CODE], then press the key.7 Rotate the DIAL to select the desired code.Set SQL CODE any one of 126 types (001 to 126).Setting the Pop-up Time of the Remote Station InformationSet the time duration to display the remote station information such as the call sign, onthe LCD.1 Touch [2 DIGITAL].2 Touch [2 DIGI POPUP].3 Rotate the DIAL to select the desired setting.OFF The remote station information is not displayed.BND2s to60sSet the time duration to display the remote station information (2 to60 seconds).BND2s / BND4s / BND6s / BND8s / BND10s / BND20s / BND30s /BND60sBNDCNT The remote station information is continuously displayed.Remark The default setting: BAND 10 seconds