118Communicating with a Specific Remote StationCalling Only a Specific Station New Pager Function3 Touch [SIGNALING].4 Touch [6 New Pager Function].5 Rotate the DIAL to select [CODE-TX], then press the key.6 Rotate the DIAL to select the first element of the code used by the remote station, thenpress the key.Caution Register the pager code of the remote station in advance.The cursor moves.7 Rotate the DIAL to select the second element of the code used by the remote station,then press the key.8 Press .The code is set and the transceiver exits from Set mode.9 Press .The remote station is called.Being Called by the Remote Station (Standby Operation)If you turn on the Bell Function ( see page 114), you are alerted to a call from theremote station by the [PAG] display, the blinking [ ] icon, and the Bell sound. Also, if youturn on the vibrator function ( see page 113), the vibrator can alert you that you havebeen called by the remote station.BlinksWhen calledTipPressing and holding the key for over one second, and then selecting [SIGNALING] → [6New Pager Function] → [ANS-BACK] → [ON] in Set mode, automatically places the transceiver intransmission mode (for about 2.5 seconds) when called by the remote party, and notifies the remoteparty that you are ready to communicate.
