ENGINE6-48 TNV IDI Service ManualCylinder BlockFigure 6-692. Measure the connecting rod twist(Figure 6-70, (1)) and bend (Figure 6-70, (2))using a connecting rod alignment tool(Figure 6-71). Record the measurements. SeeConnecting Rod on page 6-11 forspecifications.Figure 6-70Figure 6-713. Place the connecting rod bearing inserts intothe connecting rod and connecting rod cap.Install the rod cap and tighten the bolts to thespecified torque.4. Measure the inside diameter. Record themeasurements. See Crankshaft on page 6-7 forspecifications.Inspection of Tappets1. Inspect the tappet contact surfaces forabnormal wear (Figure 6-72, (1)). Normal wearwill be even as shown in (Figure 6-72, (2)).Slight surface defects can be corrected usingan oilstone.Figure 6-722. Measure the outside diameter of the tappetstem (Figure 6-73, (1)). Record themeasurements. See Tappet on page 6-12 forthe service limit.Figure 6-733. Measure the tappet bores in the cylinder block.Record the measurements. See Tappet onpage 6-12 for the service limit.0001724A(1)(2)0001896(1)(2)00002420002194(1) (2)0002195
