ALTERNATOR11-12 TNV IDI Service ManualAlternator9. Remove the stator assembly(Figure 11-10, (1)) from the front framehousing.Figure 11-1010. If it is necessary to replace the bearing(Figure 11-10, (2)) in the front frame housing,remove the four bolts (Figure 11-10, (3))securing the plate (Figure 11-10, (4)) to thefront frame housing. Remove the plate. Use apuller to remove the bearing. Discard thebearing.11. If it is necessary to replace the bearing(Figure 11-11, (1)) in the rear frame housing,use a puller to remove. Discard the bearing.Remove the bearing cover (Figure 11-11, (2))and two thrust washers (Figure 11-11, (3)).Figure 11-11Reassembly of Alternator1. If removed, reinstall the two thrust washers(Figure 11-12, (3)) and bearing cover(Figure 11-12, (2)) in the rear frame housing.Lubricate the outside diameter of a new bearing(Figure 11-12, (1)). Press the bearing into therear frame housing.Figure 11-122. If removed, lubricate the outside diameter of anew front frame housing bearing. Press thebearing (Figure 11-13, (2)) into the front framehousing. Reinstall the plate (Figure 11-13, (4))to the front housing. Tighten the four bolts(Figure 11-13, (3)).Figure 11-1312430000259A1 230000260A1 230000260A12430000259A
