23-5Task RemarksConfiguring Optional Parameters Common to an NQA Test Group OptionalScheduling an NQA Test Group RequiredConfiguring the NQA ServerBefore performing TCP, UDP echo, UDP jitter or voice tests, you need to configure the NQA server onthe peer device. The NQA server makes a response to the request originated by the NQA client bylistening to the specified destination address and port number.Follow these steps to configure the NQA server:To do… Use the command… RemarksEnter system view system-view —Enable the NQA server nqa server enable RequiredDisabled by default.Configure the UDP or TCPlistening function on the NQAservernqa server { tcp-connect |udp-echo } ip-addressport-numberRequiredThe IP address and portnumber must be consistentwith those configured on theNQA client and must bedifferent from those of anexisting listening service.Enabling the NQA ClientConfigurations on the NQA client take effect only when the NQA client is enabled.Follow these steps to enable the NQA client:To do… Use the command… RemarksEnter system view system-view —Enable the NQA client nqa agent enable OptionalEnabled by default.Creating an NQA Test GroupOne test corresponds to one test group. You can configure test types after you create a test group andenter the test group view.Follow theses steps to create an NQA test group:To do… Use the command… RemarksEnter system view system-view —Create an NQA test group andenter the NQA test group viewnqa entry admin-nameoperation-tag Required