8-12To do… Use the command… RemarksDisplay the public keys of thelocal key pairsdisplay public-key local { dsa| rsa } public Available in any viewDisplay the public keys of theSSH peersdisplay public-key peer[ brief | name publickey-name ] Available in any viewFor information about the display public-key local and display public-key peer commands, refer toPublic Key Commands in the Security Volume.SSH Server Configuration ExamplesWhen Switch Acts as Server for Password AuthenticationNetwork requirementsz As shown in Figure 8-1, a local SSH connection is established between the host (the SSH client)and the switch (the SSH server) for secure data exchange.z Password authentication is required. The username and password are saved on the switch.Figure 8-1 Switch acts as server for password authenticationConfiguration procedure1) Configure the SSH server# Generate RSA and DSA key pairs and enable the SSH server. system-view[Switch] public-key local create rsa[Switch] public-key local create dsa[Switch] ssh server enable# Configure an IP address for VLAN interface 1. This address will serve as the destination of the SSHconnection.[Switch] interface vlan-interface 1[Switch-Vlan-interface1] ip address 192.168.1.40 255.255.255.0[Switch-Vlan-interface1] quit# Set the authentication mode for the user interfaces to AAA.[Switch] user-interface vty 0 4[Switch-ui-vty0-4] authentication-mode scheme# Enable the user interfaces to support SSH.
