16-10With SNMPv2c, the user needs to specify the read only community, the read and write community, thetimeout time, and number of retries. The user can inquire and configure the device through the NMS.The configurations on the agent and the NMS must match.SNMP Logging Configuration ExampleNetwork requirementsz The NMS and the agent are connected through an Ethernetz The IP address of the NMS is 1.1.1.2/24z The IP address of the VLAN interface on the agent is 1.1.1.1/24z Configure community name, access right and SNMP version on the agentFigure 16-4 Network diagram for SNMP loggingConfiguration procedureThe configurations for the NMS and agent are omitted.# Enable logging display on the terminal. (This function is enabled by default, so that you can omit thisconfiguration). terminal monitor terminal logging# Enable the information center to output the system information with the severity level equal to orhigher than informational to the console port. system-view[Sysname] info-center source snmp channel console log level informational