3-348) VerificationAfter the configuration, you can use the display command to view RRPP configuration and operationalinformation on each device.TroubleshootingSymptom:When the link state is normal, the master node cannot receive Hello packets, and the master nodeunblocks the secondary port.Analysis:The reasons may be:z RRPP is not enabled on some nodes in the RRPP ring.z The domain ID or primary control VLAN ID is not the same for the nodes in the same RRPP ring.z Some ports are abnormal.Solution:z Use the display rrpp brief command to check whether RRPP is enabled for all nodes. If not, usethe rrpp enable command and the ring enable command to enable RRPP and RRPP rings for allnodes.z Use the display rrpp brief command to check whether the domain ID and primary control VLANID are the same for all nodes. If not, set the same domain ID and primary control VLAN ID for thenodes.z Use the display rrpp verbose command to check the link state of each port in each ring.z Use the debugging rrpp command on each node to check whether a port receives or transmitsHello packets. If not, Hello packets are lost.