10-8Follow these steps to configure a TPID value globally:To do... Use the command... RemarksEnter system view system-view —Configure the TPID value in theCVLAN tag or the SVLAN tagqinq ethernet-typehex-valueOptionalBy default, the TPID value is 0x8100QinQ Configuration ExamplesBasic QinQ Configuration ExampleNetwork requirementsAs shown in Figure 10-4,z Provider A and Provider B are edge devices on the service provider network and areinterconnected through trunk ports. They belong to SVLAN 10 and 50.z Customer A1, Customer A2, Customer B1 and Customer B2 are edge devices on the customernetwork.z Third-party devices with a TPID value of 0x8200 are deployed between Provider A and ProviderB.Make configuration to achieve the following:z Frames of VLAN 200 through VLAN 299 can be exchanged between Customer A1 and CustomerA2 through VLAN 10 of the service provider network.z Frames of VLAN 250 through VLAN 350 can be exchanged between Customer B1 and CustomerB2 through VLAN 50 of the service provider network.Figure 10-4 Network diagram for VLAN transparent transmission configurationConfiguration procedure
