2-6Load Sharing Mode of an Aggregation GroupThe link aggregation groups created on the Switch 4210G Family always operate in load sharing mode,even when they contain only one member port.Link Aggregation Configuration Task ListComplete the following tasks to configure link aggregation:Task RemarksConfiguring a Static Aggregation GroupConfiguring anAggregation Group Configuring a Dynamic Aggregation GroupRequiredPerform either of the tasksConfiguring the Description of an AggregateInterface OptionalEnabling LinkUp/LinkDown Trap Generationfor an Aggregate Interface OptionalConfiguring anAggregate InterfaceShutting Down an Aggregate Interface OptionalConfiguring a Load Sharing Mode for Load-Sharing Link AggregationGroups OptionalConfiguring an Aggregation Groupz The following ports cannot be assigned to an aggregation group: Stack ports, RRPP-enabledports, MAC address authentication-enabled ports, port security-enabled ports, IP sourceguard-enabled ports, and 802.1x-enabled ports.z You are recommended not to assign reflector ports of port mirroring to an aggregation group. Fordetails about reflector ports, refer to Port Mirroring Configuration in the Access Volume.Configuring a Static Aggregation GroupFollow these steps to configure a Layer 2 static aggregation group:To do... Use the command... RemarksEnter system view system-view —Create a Layer 2aggregate interface andenter the Layer 2aggregate interfaceviewinterface bridge-aggregationinterface-numberRequiredWhen you create a Layer 2aggregate interface, a Layer 2static aggregation groupnumbered the same is createdautomatically.Exit to system view quit —