29-4To do… Use the command… RemarksConfigure the PoE mode for thePoE interface poe mode signalOptionalsignal (power oversignal cables) bydefault.Return to system view quit —Apply the PoEconfiguration file to oneor more PoE interfacesapply poe-profile { index index |name profile-name } interfaceinterface-rangeinterface interface-typeinterface-numberApplythe PoEconfiguration fileto thePoEinterface(s)Apply the PoEconfiguration file to thecurrent PoE interface inPoE interface view apply poe-profile { index index |name profile-name }Use either approachz After a PoE configuration file is applied to a PoE interface, other PoE configuration files can nottake effect on this PoE interface.z If a PoE configuration file is already applied to a PoE interface, you must execute the undo applypoe-profile command to remove the application to the interface before deleting or modifying thePoE configuration file.z If you have configured a PoE interface through the command line, you cannot configure it througha PoE configuration file again. If you want to reconfigure the interface through a PoE configurationfile, you must first remove the command line configuration on the PoE interface.z You must use the same mode (command line or PoE configuration file) to configure the poemax-power max-power and poe priority { critical | high | low } commands.Configuring PoE Power ManagementConfiguring PD Power ManagementThe power priority of a PD depends on the priority of the PoE interface. The priority levels of PoEinterfaces include critical, high and low in descending order. Power supply to a PD is subject to PDpower management policies.All PSEs implement the same PD power management policies. When the PSE supplies power to aPD,z By default, no power will be supplied to a new PD if the PSE power is overloaded.z Under the control of a priority policy, the PD with a lower priority is first powered off to guaranteethe power supply to the new PD with a higher priority when the PSE power is overloaded.