9-14z When you configure the password for switching user privilege level with the super passwordcommand, the user privilege level is 3 if no user privilege level is specified.z The password for switching user privilege level can be displayed in both cipher text and simpletext. You are recommended to adopt the former as the latter is easily cracked.Modifying command levelAll the commands in a view are defaulted to different levels, as shown in Table 9-3. The administratorcan modify the command level based on users’ needs to make users of a lower level use commandswith a higher level or improve device security.Follow these steps to modify the command level:To do… Use the command… RemarksEnter system view system-view —Configure the command levelin a specified viewcommand-privilege levellevel view view commandRequiredRefer to Table 9-3 for thedefault settings.You are recommended to use the default command level or modify the command level under theguidance of professional staff; otherwise, the change of command level may bring inconvenience toyour maintenance and operation, or even potential security problem.Displaying and Maintaining Basic ConfigurationsTo do… Use the command… RemarksDisplay information on system version display versionDisplay information on the system clock display clockDisplay defined command aliases and thecorresponding commands display command-aliasDisplay information on terminal users display users [ all ]Display the valid configuration undercurrent view display this [ by-linenum ]Display clipboard information display clipboardDisplay and save statistics of eachmodule’s running status display diagnostic-informationAvailable inany view