2-13[DeviceA] interface bridge-aggregation 1[DeviceA-Bridge-Aggregation1] link-aggregation mode dynamic[DeviceA-Bridge-Aggregation1] quit# Assign Layer 2 Ethernet interfaces GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 toaggregation group 1.[DeviceA] interface GigabitEthernet 1/0/1[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1[DeviceA- GigabitEthernet1/0/1] quit[DeviceA] interface GigabitEthernet 1/0/2[DeviceA-GigabitEthernet1/0/2] port link-aggregation group 1[DeviceA-GigabitEthernet1/0/2] quit[DeviceA] interface GigabitEthernet 1/0/3[DeviceA-GigabitEthernet1/0/3] port link-aggregation group 12) Configure Device BFollow the same configuration procedure performed on Device A to configure Device B.Layer 2 Aggregation Load Sharing Mode Configuration ExampleNetwork requirementsAs shown in Figure 2-3, Device A is connection to Device B by their Ethernet ports GigabitEthernet1/0/1 through GigabitEthernet 1/0/4.Configure the global load sharing mode and aggregation group-specific load sharing mode to enableaggregation group 1 to use source MAC-based load sharing mode and aggregation group 2 to usedestination MAC-based load sharing mode.Figure 2-3 Network diagram for Layer 2 aggregation load sharing mode configurationGE1/0/1GE1/0/2GE1/0/3GE1/0/4GE1/0/1GE1/0/2GE1/0/3GE1/0/4Configuration procedure1) Configure Device A# Configure the global link aggregation load sharing mode as the source MAC-based load sharingmode. system-view[DeviceA] link-aggregation load-sharing mode source-mac# Create Layer 2 aggregate interface Bridge-aggregation 1.[DeviceA] interface bridge-aggregation 1[DeviceA-Bridge-Aggregation1] quit
