23-17To do… Use the command… RemarksConfigure the advantage factorfor calculating MOS and ICPIFvaluesadvantage-factor factorOptionalBy default, the advantagefactor is 0.Specify the source IP addressfor the requests in a testoperationsource ip ip-addressOptionalBy default, no source IPaddress is specified.The source IP address must bethat of an interface on thedevice and the interface mustbe up. Otherwise, the test willfail.Specify the source port numberfor the requests in a testoperationsource port port-numberOptionalBy default, no source portnumber is specified.Configure the size of a probepacket to be sent data-size sizeOptionalBy default, the probe packetsize depends on the codectype. The default packet size is172 bytes for G.711A-law andG.711 μ-law codec type, and is32 bytes for G.729 A-law codectype.Configure the filler string of aprobe packet sent data-fill stringOptionalBy default, the filler string of aprobe packet is thehexadecimal number00010203040506070809.Configure the number ofpackets sent in a voice probeprobe packet-numberpacket-numberOptional1000 by default.Configure the interval forsending packets in a voiceprobeprobe packet-intervalpacket-intervalOptional20 milliseconds by default.Configure the timeout forwaiting for a response in avoice testprobe packet-timeoutpacket-timeoutOptional5000 milliseconds by default.Configure common optionalparametersSee Configuring OptionalParameters Common to anNQA Test GroupOptionalOnly one probe can be made in one voice test, and the number of probe packets sent in each probedepends on the configuration of the probe packet-number command.Configuring a DLSw TestA DLSw test is used to test the response time of the DLSw device.
