5-6Task RemarksConfiguring Basic Ethernet OAM Functions RequiredConfiguring Errored Symbol Event Detection OptionalConfiguring Errored Frame Event Detection OptionalConfiguring Errored Frame Period Event Detection OptionalConfiguring LinkMonitoringConfiguring Errored Frame Seconds Event Detection OptionalEnabling OAM Remote Loopback OptionalConfiguring Basic Ethernet OAM FunctionsAs for Ethernet OAM connection establishment, a device can operate in active mode or passive mode.After Ethernet OAM is enabled on an Ethernet port, according to its Ethernet OAM mode, the Ethernetport establishes an Ethernet OAM connection with its peer port.Follow these steps to configure basic Ethernet OAM functions:To do… Use the command… RemarksEnter system view System-view —Enter Ethernet port view interface interface-typeinterface-number —Set Ethernet OAM operatingmode oam mode { active | passive }OptionalThe default is active EthernetOAM mode.Enable Ethernet OAM on thecurrent port oam enableRequiredEthernet OAM is disabled bydefault.To change the Ethernet OAM operating mode on an Ethernet OAM-enabled port, you need to firstdisable Ethernet OAM on the port.Configuring Link MonitoringAfter Ethernet OAM connections are established, the link monitoring periods and thresholdsconfigured in this section take effect on all Ethernet ports automatically.
