23-12To do… Use the command… RemarksConfigure the number ofpackets sent in a UDP jitterprobeprobe packet-numberpacket-numberOptional10 by default.Configure the interval forsending packets in a UDP jitterprobeprobe packet-intervalpacket-intervalOptional20 milliseconds by default.Configure the time for waitingfor a response in a UDP jittertestprobe packet-timeoutpacket-timeoutOptional3000 milliseconds by default.Configure the source IPaddress of a probe request in atest operationsource ip ip-addressOptionalBy default, no source IPaddress is specified.The source IP address must bethat of an interface on thedevice and the interface mustbe up. Otherwise, the test willfail.Configure common optionalparametersSee Configuring OptionalParameters Common to anNQA Test GroupOptionalThe number of probes made in a UDP jitter test depends on the probe count command, while thenumber of probe packets sent in each probe depends on the configuration of the probepacket-number command.Configuring an SNMP TestAn SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to theSNMP agent and then receive a response packet.Configuration prerequisitesThe SNMP agent function must be enabled on the device serving as an SNMP agent before an SNMPtest. For the configuration of SNMP agent, see SNMP Configuration in the System Volume.Configuring an SNMP testFollow these steps to configure an SNMP test:To do… Use the command… RemarksEnter system view system-view —Enter NQA test group view nqa entry admin-nameoperation-tag —Configure the test type asSNMP and enter test type view type snmp Required
