1-7To do… Use the command… RemarksSet the delaydown timer dldp delaydown-timerdelaydown-timeOptionalBy default, thedelaydown timerexpires after 1second it istriggered.Set the DLDP handling mode when anunidirectional link is detecteddldp unidirectional-shutdown{ auto | manual }Optional. Bydefault, thehandling mode isauto.Set the DLDP operating mode dldp work-mode { enhance |normal }Optional. Bydefault, DLDPworks in normalmode.Enter Ethernet port view interface interface-typeinterface-number —Display the configuration informationabout the DLDP-enabled portsdisplay dldp { unit-id |interface-type interface-number }You can executethis command inany view.z When you use the dldp enable/dldp disable command in system view to enable/disable DLDPglobally on all optical ports of the device, this command is only valid for existing optical ports on thedevice, however, it is not valid for those added subsequently.z DLDP can operate normally only when the same authentication mode and password are set forlocal and peer ports.Resetting DLDP StatusThe command here is only valid for those ports that are DLDP down due to the detection ofunidirectional link. You can use the command here to reset the DLDP status of these ports to retrieveDLDP probes.Follow these steps to reset DLDP status:
