4-2Setting Up a Web Configuration EnvironmentYour WX series access controller products were delivered with a factory default configuration. Thisconfiguration allows you to log into the built-in Web-based management system of the access controllerproduct from a Web browser on a PC by inputting http://192.168.0.101 in the address bar of thebrowser. The default login username and password are both admin. After selecting your desiredlanguage, you can log in to the Web interface to make configuration. If you save your configuration, thedevice will boot with the configuration you made rather than the default at the next boot.Log in to the switching engine with the oap connect slot 0 command and then perform the followingoperations.1) Assign an IP address to VLAN-interface 1 of the switching engine (VLAN 1 is the default VLAN ofthe switching engine), and create a user account for the login user.# Assign an IP address to the switching engine. system-view[device] interface Vlan-interface 1[device-Vlan-interface1] ip address 192.168.0.101 24[device-Vlan-interface1] quit# Create a Web user account, setting both the user name and the password to admin and the user levelto 3 (manage level).[device] local-user admin[device-luser-admin] service-type telnet level 3[device-luser-admin] password simple admin[device-luser-admin] quit2) Configure the management IP address for the switching engine of the device (Optional).# After configuring the IP address, you can go to the Web interface of the switching engine from theWeb interface of the access controller engine by clicking the Wireless Engine button on the left upperpart of the page, as shown in Figure 4-1. 192.168.0.100 is the management IP address of the switchingengine, and slot 0 is the slot number of the switching engine.[device] oap management-ip 192.168.0.100 slot 0
