3-10To do... Use the command... RemarksConfigure RIP tounicast RIP packets peer ip-addressRequiredWhen RIP runs on the link that does notsupport broadcast or multicast, you mustconfigure RIP to unicast RIP packets.Displaying and Maintaining RIP ConfigurationTo do... Use the command... RemarksDisplay the current RIP running status andconfiguration information display ripDisplay RIP interface information display rip interfaceDisplay RIP routing information display rip routingAvailable in anyviewReset the system configuration related to RIP reset Available in RIPviewRIP Configuration ExampleNetwork requirementsA small-sized company requires that any two nodes in its small office network communicate with eachother, and that the network devices automatically adapt themselves to any topology change so as toreduce the work of manual maintenance.In this case, RIP can implement communication between any two nodes.According to the network requirements, the network topology is designed as shown in Figure 3-1.Figure 3-1 Network diagram for RIP configurationDevice Interface IP address Device Interface IP addressSwitch A Vlan-int1 110.11.2.1/24 Switch B Vlan-int1 110.11.2.2/24Vlan-int2 155.10.1.1/24 Vlan-int3 196.38.165.1/24Switch C Vlan-int1 110.11.2.3/24Vlan-int4 117.102.0.1/16