1-5HWPing server configurationThe following table describes the configuration on HWPing server, which is the same for HWPing testtypes that need to configure HWPing server.Follow these steps to configure the HWPing server:To do… Use the command… RemarksEnter system view system-view —Enable the HWPing serverfunction hwping-server enable RequiredDisabled by default.Configure a UDP listeningservicehwping-server udpechoip-address port-numRequired for UDP and jittertestsBy default, no UDP listeningservice is configured.Configure a TCP listeningservicehwping-server tcpconnectip-address port-numRequired for TCP testsBy default, no TCP listeningservice is configured.HWPing Client ConfigurationHWPing client configurationAfter HWPing client is enabled, you can create multiple test groups for different tests, without the needto enable HWPing client repeatedly for each test group.Different types of HWPing tests are somewhat different in parameters and parameter ranges. Thefollowing text describes the configuration on HWPing client for different test types.1) Configuring ICMP test on HWPing clientFollow these steps to configure ICMP test on HWPing client:To do… Use the command… RemarksEnter system view system-view —Enable the HWPing clientfunction hwping-agent enableRequiredBy default, the HWPing clientfunction is disabled.Create a HWPing test groupand enter its viewhwping administrator-nameoperation-tagRequiredBy default, no test group isconfigured.Configure the destination IPaddress destination-ip ip-addressRequiredBy default, no destinationaddress is configured.Configure the source IPaddress source-ip ip-addressOptionalBy default, no source IPaddress is configured.Configure the test type test-type icmpOptionalBy default, the test type isICMP.
