1-12To do… Use the command… RemarksSet the format of the timestamp to be sent to the log hostinfo-center timestamploghost { date | no-year-date |none }OptionalBy default, the time stampformat of the information outputto the log host is date.Be sure to set the correct IP address when using the info-center loghost command. A loopback IPaddress will cause an error message prompting that this address is invalid.Setting to Output System Information to the Trap BufferFollow these steps to set to output system information to the trap buffer:To do… Use the command… RemarksEnter system view system-view —Enable the information center info-center enable OptionalEnabled by default.Enable system informationoutput to the trap bufferinfo-center trapbuffer[ channel { channel-number |channel-name } | sizebuffersize ]*OptionalBy default, the device usesinformation channel 3 to outputtrap information to the trapbuffer, which can holds up to256 items by default.Configure the output rules ofsystem informationinfo-center source{ modu-name | default }channel { channel-number |channel-name } [ { log | trap |debug } { level severity | statestate } ]*OptionalRefer to Table 1-4 for thedefault output rules of systeminformation.Set the format of time stamp inthe output informationinfo-center timestamp { log |trap | debugging } { boot |date | none }OptionalBy default, the time stampformat of the output trapinformation is date.Setting to Output System Information to the Log BufferFollow these steps to set to output system information to the log buffer:To do… Use the command… RemarksEnter system view system-view —Enable the information center info-center enable OptionalEnabled by default.
