1-4Task RemarksCreate a Smart Link groupAdd member ports to the Smart Link groupConfiguring aSmart LinkDevice Enable the function of sending flush messages in thespecified control VLANRequiredConfiguringAssociatedDevicesEnable the function of processing flush messagesreceived from the specified control VLAN RequiredConfiguring a Smart Link DeviceA Smart Link device refers to a device on which Smart Link is enabled and a Smart Link group isconfigured, and that sends flush messages from the specified control VLAN. A member port of a SmartLink group can be either an Ethernet port or a manually-configured or static LACP aggregation group.You can configure a port or a link aggregation group as a member of a Smart Link group.Follow these steps to configure Smart Link (with ports as members of the Smart Link group):To do… Use the command… RemarksEnter system view system-view —Create a Smart Link groupand enter Smart Link groupviewsmart-link group group-id RequiredEnable the function of sendingflush messages in thespecified control VLANflush enable control-vlan vlan-idRequiredBy default, no controlVLAN for sendingflush messages isspecified.Smart Linkgroup viewport interface-type interface-number{ master | slave }quitinterface interface-type interface-numberConfigure aport as aSmart LinkgroupmemberEthernet portview port smart-link group group-id { master| slave }RequiredUse either approachFollow these steps to configure Smart Link (with link aggregation groups are members of the Smart Linkgroup):To do… Use the command… RemarksEnter system view system-view —Create a Smart Link group andenter Smart Link group view smart-link group group-id RequiredConfigure a link aggregationgroup as a member of theSmart Link grouplink-aggregation groupgroup-id { master | slave } Optional
