1-24Network diagramFigure 1-6 Network diagram for the Jitter testSwitch A Switch BHWPing ClientIP network10.1.1.1/8 10.2.2.2/8HWPing ServerConfiguration procedurez Configure HWPing Server (Switch B):# Enable the HWPing server and configure the IP address and port to listen on. system-view[device] hwping-server enable[device] hwping-server udpecho 10.2.2.2 9000z Configure HWPing Client (Switch A):# Enable the HWPing client. system-view[device] hwping-agent enable# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "Jitter".[device] hwping administrator Jitter# Configure the test type as jitter[device-hwping-administrator-Jitter] test-type Jitter# Configure the IP address of the HWPing server as 10.2.2.2.[device-hwping-administrator-Jitter] destination-ip 10.2.2.2# Configure the destination port on the HWPing server.[device-hwping-administrator-Jitter] destination-port 9000# Configure to make 10 probes per test.[device-hwping-administrator-http] count 10# Set the probe timeout time to 30 seconds.[device-hwping-administrator-Jitter] timeout 30# Start the test.[device-hwping-administrator-Jitter] test-enable# Display test results[device-hwping-administrator-Jitter] display hwping results administrator JitterHWPing entry(admin administrator, tag Jitter) test result:Destination ip address:10.2.2.2Send operation times: 100 Receive response times: 100Min/Max/Average Round Trip Time: 9/21/13Square-Sum of Round Trip Time: 18623Last complete test time: 2000-4-2 8:14:58.2Extend result:SD Maximal delay: 10 DS Maximal delay: 10
