18.4.8.4 SignalsGUID-2DC54788-86AF-4B4B-8E57-A89E30F0C433 v1Except for the BLOCK input, the rest of the inputs of this GOOSEfunction block are used for GOOSE connections. Theseconnections are visible and possible to make only if Easy GOOSEengineering is enabled. For instructions on how to enable EasyGOOSE engineering in PCM600, refer to the Engineering Manual.PID-6829-INPUTSIGNALS v3Table 467:GOOSEINTRCV Input signalsName Type Default DescriptionBLOCK BOOLEAN 0 Block of functionSRCINTOUT INTEGER 0 Source to integer outputPID-6829-OUTPUTSIGNALS v3Table 468:GOOSEINTRCV Output signalsName Type DescriptionINTOUT INTEGER Integer outputDATAVALID BOOLEAN Data valid for integer outputCOMMVALID BOOLEAN Communication valid for integer outputTEST BOOLEAN Test output18.4.8.5 SettingsPID-6829-SETTINGS v3Table 469:GOOSEINTRCV Non group settings (basic)Name Values (Range) Unit Step Default DescriptionOperation OffOn- - Off Operation Off/On18.4.8.6 Operation principle GUID-5BBDF772-3B3E-4F7C-ABE9-18CE3C1A2E2D v4The DATAVALID output will be HIGH if the incoming message is with valid data.The COMMVALID output will become LOW when the sending IED is under totalfailure condition and the GOOSE transmission from the sending IED does nothappen.The TEST output will go HIGH if the sending IED is in test mode.Section 18 1MRK 505 394-UEN AStation communication650 Line differential protection RED650 2.2 IECTechnical manual