COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000CHAPTER 6 FIXING SYSTEM6-17 P*Period of time before the machine starts standby state in response to a second press onthe Power Save key.T06-302-08c. Overheating of the EndsIn a low-temperature environment (machine temperature of lower than 12°C), an error canoccur as a result of overheating of the edges (as when small-size paper is used) while copy-ing temperature is controlled to 212°C and the temperature of the fixing upper roller is 75°Cfor a period of 60 min from power-on.If continuous printing is performed for 3 min or more, printing temperature is switchedfrom 212°C to 205°C to prevent overheating.d. Jam Recovery ModeThe sequence used after jam removal differs depending on the following conditions:1. If paper exists in the fixing/feeding assembly,The fixing heater will be turned off in response to a jam, and post-jam removal initialmultiple rotation will be excluded.2. If no paper exists in the fixing/feeding assembly,The temperature control mechanism is turned on without turning off the fixing heater,and the machine will be ready for printing immediately after jam removal.e. Power Save ModeA press on the Power Save key on the control panel causes the machine to decrease thecontrol temperature used in standby, thus reducing power consumption. The mode may bechanged as follows in user mode:Rate of saving-10%-25%-50%Low power modeControl temperature180°C155°C110°C140°CRecovery time*100V 120/230V50 sec 0 sec90 sec 55 sec180 sec 140 sec-
