COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000CHAPTER 5 SERVICE MODE5-49 TAdjusting the Developing Bias OutputBIASUse it to enter the adjustment value for the development bias.Range of 0 to 600 (A higher setting makes images lighter.)adjustmentCaution • If you have cleared the RAM on the DC controller PCB, enter the set-tings indicated on the service label.• This mode is valid only when the potential control mechanism is dis-abled.HVT-DEUse it to enter the offset value for the development high-voltage output forthe high-voltage unit.Caution If you have replaced the high-voltage unit or cleared the RAM on the DCcontroller PCB, enter the settings indicated on the new high-voltage unit.D-HV-DEUse it to enter the offset value for the development high-voltage output ofthe DC controller PCB.Caution If you have replaced the DC controller PCB or cleared the RAM on the DCcontroller PCB, enter the settings indicated on the label on the new DC con-troller PCB.COPIER>ADJUST
