Moving the printerBefore moving the printerCAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or moretrained personnel to lift it safely.CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury orprinter damage:• Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.• Disconnect all cords and cables from the printer before moving it.• If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the latch on theright side of the tray toward the front of the tray until it clicks into place.• Use the handholds located on both sides of the printer to lift it.• Make sure your fingers are not under the printer when you set it down.• Before setting up the printer, make sure there is adequate clearance around it.Use only the power cord provided with this product or the manufacturer's authorized replacement.Warning—Potential Damage: Damage to the printer caused by improper moving is not covered by the printerwarranty.Moving the printer to another locationThe printer and its hardware options can be safely moved to another location by following these precautions:• Any cart used to move the printer must have a surface able to support the full footprint of the printer.• Any cart used to move the hardware options must have a surface able to support the dimensions of the hardwareoptions.• Keep the printer in an upright position.• Avoid severe jarring movements.Maintaining the printer 219
