• Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job.• Touch Finish job without further scanning to end the last successful scan job.• Touch Restart job to restart the scan job with the same settings from the previous scan job.Reinstall missing or unresponsive imaging unit [31.xy]Try one or more of the following:• Check if the imaging unit is missing. If missing, install the imaging unit.For information on installing the imaging unit, see the “Replacing supplies” section of the User’s Guide.• If the imaging unit is installed, then remove the unresponsive imaging unit, and then reinstall it.Note: If the message appears after reinstalling the supply, then the imaging unit is defective. Replace theimaging unit.Replace unsupported cartridge [32.xy]Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For moreinformation, see the instruction sheet that came with the supply or see the “Replacing supplies” section of the User’sGuide.Note: If you do not have a replacement cartridge, then visit our Web site or contact the place where you purchasedthe printer.Replace unsupported imaging unit [32.xy]Remove the imaging unit, and then install a supported one to clear the message and continue printing. For moreinformation, see the instruction sheet that came with the supply or see the “Replacing supplies” section of the User’sGuide.Note: If you do not have a replacement imaging unit, then visit our Web site or contact the place where youpurchased the printer.Restore held jobs?Try one or more of the following:• From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk.• From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs.Scanner automatic feeder cover openClose the ADF cover.Scanner disabled by admin [840.01]Print without the scanner, or contact your system support person.Troubleshooting 251
