C-Series Debugging and Diagnostics | 1177To manually write the contents of an RPM log to the internal flash:To manually write the contents of a line card log to the internal flash:Figure 60-7. TRACE_CURR_BOOT Directory exampleDisable writing the contents of a hardware log to the internal the flash:View the hardware log contents or clear them with the following commands.:Manual reload messagesWhen the chassis is reloaded manually (through the CLI), trace messages in all of the buffers (software andhardware) in CP and linecards are saved to the flash as reload_traceRPM0_CP and reload_traceLP1 inflash:/TRACE_LOG_DIR/TRACE_CURR_BOOT. After reload, you can see these files in flash:/TRACE_LOG_DIR/TRACE_LAST_BOOT.Task Command Syntax Command ModeWrite the RPM trace log to flash. upload trace-log cp [cmd-history | hw-trace | sw-trace]EXEC PrivilegeTask Command Syntax Command ModeWrite the line card trace log to flash. upload trace-log linecard [0-7] | [hw-trace |sw-traceupload trace-log cp | [cmd-history | hw-trace |sw-trace ]EXEC PrivilegeTask Command Syntax Command ModeStop the writing the hardware log to flash. trace disable EXEC PrivilegeTask Command Syntax Command ModeView the content of the hardware log. show trace hardware slot-number EXEC PrivilegeClear the hardware log buffer clear trace hardware EXEC PrivilegeFTOS#cd /flash/TRACE_LOG_DIR/TRACE_CURR_BOOTFTOS#dirhw_traceLP0.0 hw_traceLP2.1 hw_traceLP2.4 hw_traceRPM0_CP.2hw_traceLP0.1 hw_traceLP2.2 hw_traceRPM0_CP.0 hw_traceRPM0_CP.3hw_traceLP2.0 hw_traceLP2.3 hw_traceRPM0_CP.1 hw_traceRPM0_CP.4
