828 | Port Monitoringw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Displaying Remote-Port Mirroring ConfigurationsTo display the current configuration of remote port mirroring for a specified session, enter the show configcommand in MONITOR SESSION configuration mode.To display the currently configured source and destination sessions for remote port mirroring on a switch,enter the show monitor session command in EXEC Privilege mode.To display the current configuration of the reserved VLAN, enter the show vlan command.FTOS(conf-mon-sess-50)# show config!monitor session 50source GigabitEthernet 1/2 destination remote-vlan 50 direction both mode Remote-Port-Mirroringsource vlan 4, vlan 11 - 12, destination remote-vlan 50 direction both mode Remote-Port-Mirroringno disableFTOS# show monitor sessionSessionID Source Destination Direction Mode Type--------- ------ ----------- --------- ---- ----50 Gi 1/2 remote-vlan 50 both Remote-Port-Mirroring Port-based50 Po 1 remote-vlan 50 both Remote-Port-Mirroring Port-based20 Gi 1/3 remote-vlan 60 both Remote-Port-Mirroring Flow-based10 remote-vlan 101 Gi 1/4 N/A Remote-Port-Mirroring N/ASession 50: Source session monitors a source port and sourceport-channel using VLAN 50Session 20: Source session monitors a source port configuredfor flow-based monitoring using VLAN 50 at a destinationport-channelSession 10: Destination session receives mirrored traffic onVLAN 101 at a destination portFTOS(conf-if-gi-1/2)# show vlanCodes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs,P - Primary, C - Community, I - IsolatedQ: U - Untagged, T - Taggedx - Dot1x untagged, X - Dot1x taggedG - GVRP tagged, M - Vlan-stackNUM Status Q Ports* 1 InactiveR,G 2 Active T Gi 13/7
