364 | Force10 Service Agentw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Additional Policy ConfigurationsFTSA Policy Sample ConfigurationsLine card state-change policy configurationThe following FTSA policy configuration uses the default test list hardware, which contains aline-card-state-change condition, and the default action list hardware plus the custom action show linecard4 | grep Status. Linecard 4 is then taken offline to trigger a match against the card-state-change testcondition.Task Command Command ModeAssociate a Dell Force10 TAC case number with thepolicy. Configure a case number only if you alreadyhave a case open with Dell Force10 for the policy. Thiscase number is included in action-list messages sent toDell Force10.case-number number CALLHOME POLICYDelay the subsequent execution of the test list after amatch occurs. This configuration reduces the risk ofburdening the CPU with sampling when a failurecondition has already been detected.Default: 5 minutesdampen minutes CALLHOME POLICYAssociate a Dell Force10 Problem Report (PR) numberwith the policy. Configure a PR number only if youalready have a case open with Dell Force10 for thepolicy. This PR number is included in action-listmessages sent to Dell Force10.pr-number number CALLHOME POLICYExecute the action list contingent upon the state of CPUutilization. The CPU utilization is calculated inpercentage using the 1 minute rolling average of allRPM CPUs.Default: unconditionalrun-cpu {cpu | {cp slot | any} |rpm-any} {{less-than |greater-than} percentageCALLHOME POLICYNote: If a test-list match is found, but the action-list does not execute because the run-cpu less-than condition isexists, then FTSA logs the test-list match and indicates that the action-list was prevented. However, if the triggerevent was a high or specified CPU usage condition in the test-list, then the FTSA ignores the run-cpu less-thanconfiguration.Specify the interval at which the system variablesspecified in the test-list are sampled.Default: 1 minutesample-rate CALLHOME POLICYExecute the test list multiple times. If the test limit isgreater than 1, the test list is executed immediately afterthe previous execution is complete.Default: unlimitedtest-limit CALLHOME POLICY
