90 | 802.1agw w w . d e l l . c o m | s u p p o r t . d e l l . c o mEnable CFM SNMP Traps.A Trap is sent only when one of the five highest priority defects occur, as shown in Table 5-2.FTOS#show ethernet cfm traceroute-cacheTraceroute to 00:01:e8:52:4a:f8 on Domain Customer2, Level 7, MA name Test2 withVLAN 2------------------------------------------------------------------------------Hops Host IngressMAC Ingr Action Relay ActionNext Host Egress MAC Egress Action FWD Status------------------------------------------------------------------------------4 00:00:00:01:e8:53:4a:f8 00:01:e8:52:4a:f8 IngOK RlyHit00:00:00:01:e8:52:4a:f8 Terminal MEPDelete all Link Trace Cache entries. clear ethernet cfm traceroute-cache EXEC PrivilegeTask Command Syntax Command ModeEnable SNMP trap messages forEthernet CFM.snmp-server enable traps ecfm CONFIGURATIONTable 5-2. ECFM SNMP TrapsCross-connect defect %ECFM-5-ECFM_XCON_ALARM: Cross connect fault detected by MEP 1 in Domain customer1at Level 7 VLAN 1000Error-CCM defect %ECFM-5-ECFM_ERROR_ALARM: Error CCM Defect detected by MEP 1 in Domain customer1at Level 7 VLAN 1000MAC Status defect %ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP 1 in Domainprovider at Level 4 VLAN 3000Remote CCM defect %ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in Domain customer1at Level 7 VLAN 1000RDI defect %ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain customer1 at Level7 VLAN 1000Task Command Syntax Command Mode
