500 | IPv6 Addressingw w w . d e l l . c o m | s u p p o r t . d e l l . c o mSNMP over IPv6SNMP is supported on platforms c e sSimple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 hostcan perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOSSNMP-server commands for IPv6 have been extended to support IPv6. Refer to the SNMP and SYSLOGchapter in the FTOS Command Line Interface Reference for more information regarding SNMP commands.• snmp-server host• snmp-server user ipv6• snmp-server community ipv6• snmp-server community access-list-name ipv6• snmp-server group ipv6• snmp-server group access-list-name ipv6Show IPv6 InformationAll of the following show commands are supported on platforms: c e sView specific IPv6 configuration with the following commands.Command Syntax Command Mode Purposetelnet ipv6 address EXEC orEXEC PrivilegedEnter the IPv6 Address for the device.ipv6 address : x:x:x:x::xmask : prefix length 0-128IPv6 addresses are normally written as eight groups of four hexadecimal digits,where each group is separated by a colon (:). Omitting zeros is accepted asdescribed in Addressing earlier in this chapter.Command Syntax Command Mode Purposeshow ipv6 ? EXEC orEXEC PrivilegedList the IPv6 show options
