810 | Policy-based Routingw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Figure 37-12. Showing CAM PBR Configuration ExampleSample ConfigurationThe following configuration is an example for setting up a PBR. These are not comprehensive directions.They are intended to give you a some guidance with typical configurations.You can copy and paste from these examples to your CLI. Be sure you make the necessary changes tosupport your own IP Addresses, Interfaces, Names, etc.Figure 37-13 is a graphic illustration of the configuration shown in Figure 37-14. The Redirect-List GOLDdefined in this example, creates the following rules:• description Route Gold traffic to the DS3.• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any• " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.1.0/24."• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any• " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.2.0/24."• seq 15 permit ip any anyFTOS(conf-if-gi-8/1)#do show cam pbr l 8 p0TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FINCam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hopIndex Flag Port Port MAC---------------------------------------------------------------------------------------------------------------------------------06080 0 N/A IP 0x0 0 0 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199 N/A06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234 222.222.222.222/24 00:00:00:00:0Non-Contiguous BitmasksContiguous Bitmasks
