496 | IPv6 Addressingw w w . d e l l . c o m | s u p p o r t . d e l l . c o mConfiguration Task List for IPv6This section contains information regarding the following:• Change your CAM-Profile on an E-Series system (mandatory)• Adjust your CAM-Profile on an C-Series or S-Series• Assign an IPv6 Address to an Interface• Assign a Static IPv6 Route• Telnet with IPv6• SNMP over IPv6• Show IPv6 Information• Clear IPv6 RoutesChange your CAM-Profile on an E-Series systemThe cam-profile command is supported only on platform eChange your CAM profile to the CAM ipv6-extacl before doing any further IPv6 configuration. Once theCAM profile is changed, save the configuration and reboot your router.Figure 22-4 displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profileconfigured. Figure 22-5 shows the full IPv6 CAM profiles. Refer to Chapter 11, Content AddressableMemory, on page 281 for complete information regarding CAM configuration.Figure 22-4. Command Example: show cam-profile summary (E-Series)Command Syntax Command Mode Purposecam-profile ipv6-extaclmicrocode ipv6-extacl chassis| linecard slotEXEC Privileged Enable the CAM profile with IPv6 extended ACLson the entire chassis or on a specific linecardchassis changes the CAM profile for all linecardsin the chassislinecard slot/port changes the CAM profile onlyfor the specified slotFTOS#show cam-profile summary-- Chassis CAM Profile --: Current Settings : Next BootProfile Name : IPV6-ExtACL : IPV6-ExtACLMicroCode Name : IPv6-ExtACL : IPv6-ExtACL-- Line card 1 --: Current Settings : Next BootProfile Name : IPV6-ExtACL : IPV6-ExtACLMicroCode Name : IPv6-ExtACL : IPv6-ExtACLFTOS#
