Force10 Service Agent | 349Figure 16-1. Displaying the Default FTSA ConfigurationSpecify an SMTP Server for FTSATo specify the SMTP server that will receive and forward the E-mail messages generated by FTSA:Provide an Administrator E-mail AddressFTSA is designed to send E-mail notification when a test condition is met, Type 4 messaging is enabled,and when Type 3 messaging is enabled.Task Command Syntax Command ModeSpecify an SMTP server in the form smtp.domain-name.com. smtp server-address CALLHOMEStep Task Command Syntax Command Mode1 The administrator E-mail address is the one thatFTSA uses to originate E-mails.• Enter the administrator’s full E-mail address, inthe form: username@domain.com, or• Enter the username without the domain name.Dell Force10 recommends using the system namefor username your company’s domain name fordomain.admin-email email-address CALLHOME2 If you did not enter the domain name when enteringthe administrator E-mail address, enter a domainname in the form domain-name.comIf you specify a domain with both the admin-emailand domain-name command the domain-nameconfiguration supersedes.domain-name domain_name CALLHOMEFTOS(conf-callhome)#show config!call-homeno enable-allserver Force10recipient ftsa@force10networks.comkeyadd Force10DefaultPublicKeyencryptno enable
