358 | Force10 Service Agentw w w . d e l l . c o m | s u p p o r t . d e l l . c o m 2. Create the list of actions that FTSA should take if any of the conditions exist. See Create a PolicyAction List on page 361.3. Create a policy and assign a test list and action list. See Create a Policy and Assign a Test and ActionList on page 363.4. Set optional policy parameters. See Additional Policy Configurations on page 364Figure 16-8. Creating FTSA PoliciesCreate an FTSA Policy Test ListCreate the list of conditions for which FTSA should search. You may include a pre-defined list(Table 16-1) and specify additional test conditions (Table 16-2).To create a new, empty policy test list:Choose test conditions for a policy test listOnce you create a policy test list, FTOS enters the CALLHOME TESTLIST context. The list you createdis initially empty. You may choose one of three pre-defined condition lists, or create your own.The three pre-defined condition lists are shown in Table 16-1.Task Command Command ModeCreate a policy test list and name it. policy-test-list name CALLHOMETable 16-1. Pre-defined Policy Test ListsCondition Conditions TestedException CPU above 85%, crash, task crash, dump, reload due to error, RPM failover due to errorPolicy 2Action List 2 Test List 2Policy 3Action List 3 Test List 3Policy 1Action List 1 Test List 1
