58 | System Managementw w w . d e l l . c o m | s u p p o r t . d e l l . c o m A user can access all commands at his privilege level and below.Removing a command from EXEC modeRemove a command from the list of available commands in EXEC mode for a specific privilege levelusing the command privilege exec from CONFIGURATION mode. In the command, specify a level greaterthan the level given to a user or terminal line, followed by the first keyword of each command to berestricted.Move a command from EXEC Privilege mode to EXEC modeMove a command from EXEC Privilege to EXEC mode for a privilege level using the command privilegeexec from CONFIGURATION mode. In the command, specify the privilege level of the user or terminalline, and specify all keywords in the command to which you want to allow access.Allow Access to CONFIGURATION mode commandsAllow access to CONFIGURATION mode using the command privilege exec level level configure fromCONFIGURATION mode. A user that enters CONFIGURATION mode remains at his privilege level, andhas access to only two commands, end and exit. You must individually specify each CONFIGURATIONmode command to which you want to allow access using the command privilege configure level level. In thecommand, specify the privilege level of the user or terminal line, and specify all keywords in the commandto which you want to allow access.Allow Access to INTERFACE, LINE, ROUTE-MAP, and ROUTER mode1. Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE,ROUTE-MAP, and ROUTER modes, you must first allow access to the command that enters you intothe mode. For example, allow a user to enter INTERFACE mode using the command privilegeconfigure level level interface gigabitethernet2. Then, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to whichyou want to allow access using the command privilege {interface | line | route-map | router} level level.In the command, specify the privilege level of the user or terminal line, and specify all keywords in thecommand to which you want to allow access.The following table lists the configuration tasks you can use to customize a privilege level:Task Command Syntax Command ModeRemove a command from the list of available commandsin EXEC mode.privilege exec level level{command ||...|| command}CONFIGURATIONMove a command from EXEC Privilege to EXEC mode. privilege exec level level{command ||...|| command}CONFIGURATIONAllow access to CONFIGURATION mode. privilege exec level levelconfigure CONFIGURATION
