Policy-based Routing | 809Show Redirect List ConfigurationTo view the configuration redirect list configuration, use the following command in EXEC mode:List the redirect list configuration using the show ip redirect-list redirect-list-name command.The non-contiguous mask is displayed in dotted format (x.x.x.x). The contiguous mask is displayed in /xformat. Some sample outputs are shown in Figure 37-10, Figure 37-11, and Figure 37-12.Figure 37-10. Showing Redirect List Configuration Example 1Use the show ip redirect-list (without the list name) to display all the redirect-lists configured on thedevice.Figure 37-11. Showing Redirect List Configuration Example 2Command Syntax Command Mode Purposeshow ip redirect-listredirect-list-nameEXEC View the redirect list configuration and the associatedinterfaces.show cam pbrshow cam-usageEXEC View the redirect list entries programmed in the CAM.Note: If, the redirect-list is applied to an interface, the output of show ip redirect-listredirect-list-name command displays reachability and ARP status for the specified next-hop.FTOS#show ip redirect-list xyzIP redirect-list xyz:Defined as:seq 5 redirect 3.3.3.3 ip host 222.1.1.1 host 77.1.1.1FTOS#show ip redirect-listIP redirect-list rcl0:Defined as:seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24 eq 40 ack, Next-hop reachable(via Gi 8/1), ARP resolvedApplied interfaces:Gi 8/0Non-Contiguous BitmasksContiguous Bitmasks
