354 | Force10 Service Agentw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Set the Frequency of FTSA Type 3 MessagesWhen messaging is enabled, FTSA sends an E-mail every 24 hours containing inventory information to allrecipients. There is no facility for setting the frequency for individual recipients.Generate FTSA Type 4 MessagesFTSA can collect and E-mail a user-defined subset of the local system log.These E-mails are Type 4, andType 4 messages are enabled by default:After the initial message, subsequent messages only include log entries with that were generated after thelast message was sent to the server so that log messages are not repeated in multiple E-mails.Set Parameters FTSA Type 5 MessagesFTSA Type 5 messages have two configurable parameters:Task Command Command ModeSet the frequency at which FTSA generatesinventory E-mails.Range: 2 to 10080 minutesDefault: 1440 minutes (24 hours)frequency minutes CALLHOMEStep Task Command Command Mode1 Ensure that system logging is on,and verify the logging severitylevel.logging ondo show running-config loggingCONFIGURATION2 Collect and E-mail system logmessages.• If you do not use the severityoption, FTSA uses 7 by default.• This is the recommendedseverity level. Lower valueswill result in partial log datasent to the server becausemessages with higher valuesare filtered out.log-messages [delay minutes][severity level] [filter string]CONFIGURATIONTask Command Command ModeDivert Type 5 messages to the internal flashdirectory /CALL-HOME-LOGS instead of sendingthem to FTSA recipients. Filenames include theaction list name and a timestamp, and use the fileextension .ftsa.log-only CALLHOME ACTIONLIST
