1030 BigIron RX Series Configuration Guide53-1001986-01Clearing sFlow statistics39Displaying sFlow counterssFlow counters are included in the output of the show interface ethernet command.In the output, the sFlow counters show:• ignored - Bad Ethernet frames were received which includes CRC, runts, giants, and malformedframes• DMA received - Good packets were received• DMA transmitted - Good packets were transmittedSyntax: show interface ethernetClearing sFlow statisticsTo clear the UDP packet and sFlow sample counters in the show sflow display, enter the followingcommand.BigIron RX(config)# clear statistics.Syntax: clear statisticsThis command clears the values in the following fields of the show sflow display:• UDP packets exportedPort Sampling Rates The sampling rates of a port on which sFlow is enabled.Hardware Sample Rate The actual sampling rate. This is the same as the Global Sample RateTABLE 167 sFlow information (Continued)This field... Displays...BigIron RX(config)# show interface ethernet 1/1GigabitEthernet2/1 is disabled, line protocol is down, link keepalive isenabledHardware is GigabitEthernet, address is 000c.dbe2.5900 (bia 000c.dbe2.5900)Configured speed 1Gbit, actual unknown, configured duplex fdx, actual unknownConfigured mdi mode AUTO, actual unknownMember of 2 L2 VLANs, port is tagged, port state is DisabledSTP configured to ON, Priority is level7, flow control enabledForce-DSCP disabledmirror disabled, monitor disabledNot member of any active trunksNot member of any configured trunksNo port nameMTU 1522 bytes, encapsulation ethernet300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization0 packets input, 0 bytes, 0 no bufferReceived 0 broadcasts, 0 multicasts, 0 unicasts0 input errors, 0 CRC, 0 frame, 0 ignored0 runts, 0 giants, DMA received 0 packets0 packets output, 0 bytes, 0 underrunsTransmitted 0 broadcasts, 0 multicasts, 0 unicasts0 output errors, 0 collisions, DMA transmitted 0 packets
