BigIron RX Series Configuration Guide 5953-1001986-01System Monitoring Service 3Specify the parameter if you want to save the configuration changes to a directoryother than the root directory of a flash card file system.The parameter indicates the name of the saved configuration file.To change the save location back to flash memory, enter a command such as the following.BigIron RX# locate startup-config flash-memory switch1.cfgBigIron RX# write memoryFile management messagesThe following table lists the messages the CLI can display in response to file managementcommands.System Monitoring ServiceThe System Monitoring Service (SYSMON) feature monitors the hardware in the system to detect,report, and in some cases isolate and recover hardware errors in the system. When an error orevent occurs, SYSMON generates Syslog messages, which must be reported to Brocade TechnicalSupport.SYSMON provides the following:• A read and write test was added to detect failed Switch Fabric Module (SFM) FE failures. ASyslog message is generated to indicate a SFM FE failure.TABLE 33 Flash card file management messagesThis message... Means...File not found You specified a file name that the software could not find. Verify thecommand you entered to make sure the command matches the sourceand destination you intended for the file operation.Current directory is: You have successfully changed the management focus to the slot andsubdirectory indicated by the message.Path not found You specified an invalid path.There is not enough space on the card The flash card does not have enough space to hold the file you are tryingto copy to it.Access is denied You tried to copy or delete a file that has the read-only attribute.A duplicate file name exists You tried to rename a file using a name that is already in use by anotherfile.Fatal error, can not read or write media A hardware error has occurred. One possible cause of this message is ifyou removed the flash card while a file operation involving the card wasin progress.There is sharing conflict betweenformat command and other read/writeoperationsThe flash card is currently undergoing formatting. This message alsocan show up if you enter a command to format the card while the card isbeing accessed for another file operation.Invalid DOS file name A filename you entered contains an invalid character (for example, “:” or“\”).File recovered successfully and namedA file you tried to recover was successfully recovered under the nameindicated in the message
