BigIron RX Series Configuration Guide 44153-1001986-01Configuring a topology group 16If you remove a member VLAN or VLAN group from a topology group, you will need toreconfigure the Layer 2 protocol information in the VLAN or VLAN group.Configuring a topology groupTo configure a topology group, enter commands such as the following.BigIron RX(config)# topology-group 2BigIron RX(config-topo-group-2)# master-vlan 2BigIron RX(config-topo-group-2)# member-vlan 3BigIron RX(config-topo-group-2)# member-vlan 4BigIron RX(config-topo-group-2)# member-vlan 5BigIron RX(config-topo-group-2)# member-group 2The commands configure topology group 2 and add the following to it:• VLAN 2 as master VLAN• VLANs 3, 4, and 5 as member VLANs• Member VLAN group 2Syntax: [no] topology-group The command creates a topology group.The parameter assigns an ID 1 – 256 to thetopology group.Syntax: [no] master-vlan This command adds the master VLAN to the topology group. The VLAN must already be configured.Make sure all the Layer 2 protocol settings in the VLAN are correct for your configuration before youadd the VLAN to the topology group. A topology group can have only one master VLAN.Syntax: [no] member-vlan <vlan-id>This command adds a member VLAN to the topology group. The VLAN must already be configured.Syntax: [no] member-group This command adds a VLAN group to the topology group. The specifies a VLAN group ID.The VLAN group must already be configured.Displaying topology group informationThe following sections show how to display topology group information for VLANS.Displaying topology group informationTo display topology group information, enter the following command.
