496 BigIron RX Series Configuration Guide53-1001986-01QoS for the oversubscribed 16 x 10GE modules18Configuring QoS for the 16 x 10G moduleNew CLI commands have been added to allow alternating between server and storage modes onthe 10 x 16GE module. The new commands are part of the qos group, and configured at theinterface level.Configuration steps1. To set the group port 1 weight, low prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 12. To set the group port 1 weight, high prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2NOTEThe configurations for group port 1 will now be associated to s/1,s/5,s/9,s/133. To set the group port 2 weight, low prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 14. To set the group port 2 weight, high prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 1 2NOTEThe configurations for group port 2 will now be associated to s/2,s/6,s/10,s/145. To set the group port 3 weight, low prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 1 2 16. To set the group port 3 weight, high prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 1 2 1 2NOTEThe configurations for group port 3 will now be associated to s/3,s/7,s/11,s/157. To set the group port 4 weight, low prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 1 2 1 2 18. To set the group port 4 weight, high prioriy traffic, enter the following command.BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 1 2 1 2 1 2NOTEThe configurations for group port 4 will now be associated to s/4,s/8,s/12,s/16Syntax: [no]qos rcv-scheduler fq-sp l wfg [num]Use rcv-scheduler to change the receive scheduling parameters on the 16x10G card.Use scheduler to assign a scheduling mechanism to one or more ports.Use the no parameter to return to the default mode. (Server)Use the fq-sp parameter to set the 16x10G module to fair queuing strict priority mode.
